Research Field
Bevel Gear Cutting


Bevel Gear Cutting

In soft tooth cutting of spiral bevel and hypoid gears, a productivity and tool life leap was obtained by the introduction of dry machining with coated carbide tools.
However, there have been no or few publications about systematic studies and further development of this technology.
In the project, High Speed manufacturing of Bevel Gears", which is funded by the AiF, numerous parameters of the technological system are made subject to systematic studies.



Do you have questions concerning this research area?

Your contact:
Mareike Solf, M.Sc.
Manfred-Weck-Haus 113
Tel.: +49 241 80-26290
Fax: +49 241 80-22293